AUTONET TV

Not Too Hot and Not Too Cold (Temperature Gauge)

You know your body temperature is supposed to be 98.6 degrees F, 37 degrees C.  Your vehicle has a normal temperature, too, and if you pay attention to it, that can save you some big headaches down the road.

Many vehicles have a temperature gauge on the dash that takes the temperature of the engine's coolant.  Some have a thermometer symbol, some read C-H (cold to hot). Many will have a red zone that shows when water temperature is getting into the danger zone.  Others are digital and have a red warning light that signals overheating.  And some vehicles have a light that goes on when the engine temperature is out of the normal range.

If your vehicle has a gauge, pay attention to it.  If you need help locating it, ask one of our Franklin Auto Service experts to give you a quick explanation.  Chances are when the vehicle has been running for 15 minutes or more, the temperature gauge will settle into its own "normal" zone, often just below the midway point.  If you have a digital readout, remember what that "normal" temperature is.  Here's why.

At any point when you're driving, the temperature gauge is the quickest way to get a sense that the engine is running the way it should, a quick health checkup, as it were. Say you're on a 3-hour trip, glance at that gauge every hour or so.  It should always be in the same spot.  If it starts to move one way or the other, you may be able to catch a problem before it gets serious.

Pay special attention to it moving into the hot zone.  The needle on the gauge is the easiest and least distracting way to see an engine heating up, but on a digital gauge, start paying attention if the temperature reaches 240ºF/115ºC or more.

Remember, though, that just because the gauge reads "hot" doesn't mean your engine is on the verge of burning up.  It could be a bad sensor and the engine will be at a normal temperature.  But it also could be a failing water pump, coolant leak or thermostat.  By pulling off the road and observing your engine, it will give you a pretty good idea if it's running hot or not.

If the gauge is too "cold," it could be a broken gauge or thermostat sticking open.  Usually being in the cold range isn't as worrisome, but you should have it checked out since other systems may be affected.

Heat is one of a vehicle's worst enemies, especially when it comes from within.  Know your vehicle's normal temperature and keep an eye on it.

Franklin Auto Service
32725 Franklin Rd
Franklin, MI 48025
248-626-2080
http://www.franklinautoservice.net

Have a Ball! Know your Ball Joints (Ball Joints)

We all have joints in our own skeletal system, but did you know your vehicle has some joints of its own? One of the most important is called a ball joint.

One of the interesting things is that it's somewhat similar to the ball and socket joints we have in our hips and shoulders.  A ball joint allows two parts it joins together to move in more than one direction at the same time.

Think about your wheels.  They have to move up and down when there are bumps in the road but in sideways directions when you are making a turn. As you can see, the ball joints are important for your steering and handling to work correctly.

Since ball joints do so much, they can wear out and become loose.  When the ball wears down or the socket gets worn, there can be too much play in them.  It can get so bad that the ball can come out of the socket and your wheel can fall off, a dangerous situation.  Ball joints can also seize up.  Some of them are sealed and never require maintenance; others require periodic lubrication.

Here are some signs that your ball joints are going bad:

• Your vehicle pulls to one side
• You can hear a clunking noise coming from a wheel area
• Your tires are wearing unevenly, especially on the inside

The earlier a failing ball joint is discovered, the better. The best way is to have regular inspections by a technician.  Your service facility will periodically check ball joints at intervals recommended by the manufacturer. The cost to replace them can vary widely depending on whether you have a vehicle with a 2-ball or 4-ball configuration.  Also, sometimes just the joints can be replaced, but other times they are part of a larger control arm assembly that has to have all the parts replaced at the same time. 

Your vehicle's proper steering, handling and tire wear all contribute to a better, safer driving experience.  Make sure your ball joints are up to the job.

Franklin Auto Service
32725 Franklin Rd
Franklin, MI 48025
248-626-2080
http://www.franklinautoservice.net

Fuel Saving Tip: Auto Myths Around Franklin

With high fuel prices in Franklin, MI, comes lots of gas saving advice. Some of it, like what you hear on   is great.  When you get one of those e-mails that's going around telling you how to save gas, try to think it through.

Does it really make sense? Does it defy the laws of physics?

Do some research on the internet or ask your Franklin, MI, service advisor at Franklin Auto Service.

There aren't any magic pills you can drop in your gas tank, and the government hasn't suppressed a device you can clamp on your fuel line to make your vehicle run on air. Not even in Franklin!

So next time you get one of those e-mails, check it out with an automotive professional. You'll get more bang for your buck with an oil change or an engine air filter replacement.

We're here for you at Franklin Auto Service, so give us a call at 248-626-2080 for good honest advice about your vehicle.

Franklin Auto Service
32725 Franklin Rd
Franklin, MI 48025
248-626-2080
http://www.franklinautoservice.net

Conventional or Synthetic? (Switching to Synthetic Oil)

If you keep up on technology trends, then you may be intrigued about synthetic motor oil.  It was introduced in the 1960s when Mobil came up with it.  Mobil's oil was different from conventional motor oil because it was first broken down to its basic molecules.  Then, Mobil removed additional impurities from crude oil and "tailored them to the demands of modern engines."

Synthetic oil is becoming more popular now because of its advantages over conventional oil. It's more resistant to sludge forming in an engine.  It is more efficient and protects engines better under temperature extremes.  Because it allows drivers to go longer between oil changes, many feel it's more convenient. 

The downside is that synthetic oil is more expensive, but because it doesn't need changing as often, the cost can be pretty comparable in the long run.

Those who drive high performance vehicles (think Audi, BMW, Mercedes) are already using synthetic oil if they're following their manufacturer's guidelines.  Other manufacturers recommend a synthetic blend.  So for those who are using conventional oil, you may want to consult your service advisor for some recommendations if you want to switch to synthetic. 

If you're the type who always waits until the last-minute or doesn't ever get in quite in time for the recommended oil change interval, the longer gap required between changes with synthetic oil may appeal to you.  In some cases, you can go up to 15,000 miles/24,000 km between changes. 

If you drive in a very cold climate, synthetic oil can flow more easily at startup and may offer quicker engine protection.  On the other hand, in hot climates, synthetic oil can resist heat breakdown better.

Or you may be one of those drivers who have been getting along fine with conventional oil changes.  Millions do.  Just remember that changing your oil is considered the most important maintenance you can do on your vehicle, so make sure it's done at the right time and with the oil that best suits your driving needs.

Franklin Auto Service
32725 Franklin Rd
Franklin, MI 48025
248-626-2080
http://www.franklinautoservice.net